Systec It3 - User Manual Verified

Since Systec IT3 typically refers to a specialized industrial Isolated Tag Transmitter (commonly used in mining and heavy industry for tracking vehicles and personnel via Leaky Feeder or WiFi infrastructure), a general "user manual" is often hard to find publicly. Below is a useful write-up designed to serve as a Quick-Start Guide and Operational Overview for the Systec IT3. This covers the essential setup, configuration, and troubleshooting steps usually found in the full technical manual.

Systec IT3 User Manual: Operational Quick-Start Guide 1. Device Overview The Systec IT3 is an Isolated Tag Transmitter designed to generate identification signals for tracking assets, vehicles, or personnel. It is engineered for harsh environments and typically integrates with a Leaky Feeder communication system or a standard WLAN/WiFi network. Key Functions:

Transmits a unique ID code at set intervals. Isolation circuitry protects the connected network from ground faults and electrical noise (crucial in mining/tunnelling). Low power consumption for battery-operated longevity.

2. Physical Installation CAUTION: Ensure power is disconnected before wiring. Mounting systec it3 user manual

Mount the unit in a location protected from direct impact and excessive moisture. Use the provided mounting brackets. Ensure the antenna (if external) has a clear line of sight or proper coupling with the Leaky Feeder cable.

Wiring Diagram (Typical Configuration)

Power Input: Connect the DC power source (typically 12V–24V DC) to the designated terminals. Observe polarity (Red: +V, Black: GND). Data/Signal Output: Connect the output leads to the Leaky Feeder insertion point or the network data line. Grounding: Connect the chassis ground terminal to a validated earth ground to ensure the isolation circuitry functions correctly. Since Systec IT3 typically refers to a specialized

3. Configuration & Programming The IT3 is typically configured via a serial interface (RS232/RS485) or USB, depending on the revision, using Systec configuration software. Setting the Tag ID

Connect the IT3 to a PC running the configuration utility. Power on the device. Select the "Read Device" function to display current settings. Enter the desired Tag ID (unique identifier number). Set the Transmission Interval :

Low Power Mode: Longer intervals (e.g., every 60 seconds) to save battery. High Visibility Mode: Shorter intervals (e.g., every 5 seconds) for real-time tracking. Systec IT3 User Manual: Operational Quick-Start Guide 1

Setting the Baud Rate (If applicable) Match the communication baud rate with the receiving infrastructure (e.g., 9600 or 19200 bps). Mismatched baud rates will result in no data being received on the surface. 4. Operation Once powered and configured:

The Status LED will flash (typically Green) to indicate an active transmission. The device will broadcast its ID according to the programmed interval. If connected to a Leaky Feeder system, ensure the signal amplifier on the line is active.